1. Close the door of the incubator to prevent gas leakage and affect the test results;
2. After the refrigeration system stops working, wipe the working chamber and the glass observation window with a soft cloth;
3. Before each stop, each control switch should be in the non-working state to cut off the power;
4. The carbon dioxide incubator should be placed on a flat surface, and the environment should be clean and tidy, dry and ventilated;
5. Do not adjust the pressure of the inflowing gas to an excessive level to avoid breaking the pipeline and damaging the detector;
6. Before using the instrument, each control switch should be in non-working state, and the speed control knob should be placed in the minimum position;
7. Proper use and attention to the maintenance of the instrument, so that it is in good working condition, can extend the life of the instrument;
8. Not applicable to the cultivation of articles containing volatile chemical solvents, low concentrations of explosive gases and low ignition gases, and toxic substances.
9. Keep the air in the incubator clean and disinfect regularly; always pay attention to the amount of distilled water in the distillation tank to keep the relative humidity inside the tank while avoiding evaporation of the culture solution;
10. During continuous operation, the instrument should be regularly inspected every three months; check for water droplets, dirt, etc. falling into the motor and exposed refrigeration components; cleaning dust and dirt on the compressor and condenser; Fuses, control elements and fastening screws;
Inkjet Receptive Coating, Anticorrosion Pigments, Matting Agent
